[Summer] Replace the new mahogany panel and central control cover
SidneyEdith 
12 First of all, I would like to thank the Xiamen brothers for removing the parts![]()
![]()
, my front cover windshield and air outlet have been broken. It has been several years, and it was fixed with glue to death. Some time ago, I talked to him about whether I could remove one for me. He quickly removed it. The problem was that it was too big to use wooden frames to deliver goods, so the dead horse was treated as a living horse. He didn’t use wooden frames to send it like this, so he threw it away when it was broken. In the end, I was happy in good condition. Nanchang’s 39 degrees weather forecast temperature, but it was actually estimated to be 93 degrees. Working in the car with the air conditioner, the old one broke into pieces with a twist and directly broke in half
Put it on and compare it
The original factory’s color faded badly and it turned green
It was removed and broke in half. The soundproof cotton was removed and put back on it. It was used for double soundproof.
Stick the black foam cotton back under the windshield, put the light sensor and anti-theft light back together, and you can buckle it back up
Done, take the decorative board of the a-pillar back and complete the task. It looks better than the original green one, right?
Shunbian asked him to issue a set of pedals. Two of my original car’s pedals were not bright and two were semi-bright. I took the ones that were not bright and disassembled them for research. I should buy my own LEDs to repair them. Next time I have time, I should buy them and repair them.
back
Break the iron hook and remove the iron plate
light emitting panel
The back is paper, plastic paper and foam glue. The inside is transparent acrylic. The light strap is attached vertically. The luminescent sheet lights up as a whole and makes it soft. The plastic paper is semi-transparent and can light up the logo.
This is the luminous surface
It’s very thin, but it can be replaced. If it’s made of glue, you can just replace it directly.
Didn’t buy led and update it later
very thin
Biu ke brand
Change the pedal, just lift it up and change the cord
The co-pilot was also replaced
Can you tell which one is from the original factory?
Take a look at the details. On the left is the car demolished in 2008, and on the right is the original car in 2005. The original car has rubber sealing clips. The metal clips are of very good quality and are not rusty! The car scrapper on the left in 2008 was actually rusty! Look at old cars. There’s still something about them.
Old laid-off
off the lights
Turn on the lights and you can tell the difference during the day
This packaging is very careful, thank you brother
Light colored sultry series
Old color matching
new color
Three years younger
The old one is still so strong after being demolished countless times
Officially laid off
Zhongmen Electric is also here
The pulling force of my middle door motor was no longer enough, so I removed two at the same time. If the electric door couldn’t open the door with remote control or switch, but I could open the door with my hand, I guess this pulling force was no longer enough. I would replace it in two days. I would first beautify myself and then toss it over
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
