Old car pressure relief valves may need to be replaced
HerbertLeopold 
14 When sorting out the main line, I found that the threading position of the reversing radar behind was a bit strange, so I pulled out an accessory that was most easily ignored. If there are problems, you must fix them and you can’t let them go
Scalp tingling no
Lower corner of rear air conditioner fan
I always thought it was dirty inside, but I couldn’t figure out why
After installing a reversing radar cable, I actually entered from here
It’s still connected inside and outside the car
Later I learned that this was called a pressure relief valve
Two screws on the left rear wheel eyebrow
Several buckles on the rear bar
miserable
Comparison between old and new
aging damage
The leaves are light and soft, I don’t know what material is made of
Stick it out and replace it
There are buckles on the upper edge and bottom of the rear lever. Remove two to pull the lever out obliquely.
The plastic positioning on the edge of the rear bumper was hit by a forklift and broke.
Loading semi-finished trailer bars
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
