Rear electric sunshade was successfully repaired
The fixed plastic on both sides of the rear electric sunshade is broken. It is too expensive to replace the assembly. If you don’t replace it, you will feel uncomfortable to have this function. So I learned the maintenance methods of my predecessors in the forum and finally repaired them after experimenting with two kinds of glue
Use a rocker to lift the cover and come down, and then pull it out to come out.
This is the first time I have used 3M glue with a viscosity of CA40. After drying for 24 hours and installation, it lasted for 3 seconds and broke…
Then I chose to use 3M glue with a viscosity of 1500. Perfect repair. Pay attention to repair it with a blade if there is too much glue dripping, otherwise it will easily get stuck and cause severe friction.
It dried for one day. During installation, this black square cover must be installed before covering the repaired link plastic.
Pay attention to lowering it to the bottom when installing.
I have been using it for a week and it is quite strong.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024
Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024
You May Like