Replace sprocket sleeve, machine filter base, machine foot three-piece set, etc.

  9
 September 3, 2024
I just wanted to replace the sprocket wheel, but I found that there were still many problems. Why don’t you just clean it up?

The left sprocket pack comes from Teacher Tian of the forum
The original filter base on the right (the original factory is MAHLE) 2711801410 (1750)
Modified BMTES Air Inlet Pipe Assembly 271090098 (110)
Thermostat MAHLE (complete accessory information)(290)
Owl engine foot (parts without packaging and labeling) 2122400418 (260)
Owl gearbox foot (parts are packaged without identification) 2042404217 (120)
Right sickle water pipe (complete information) 2122002352 (60)

Comparison between old and new

Comparison between old and new

Comparison between old and new

Comparison between old and new

Comparison between old and new

Improved comparison of old and new

Replacement of the gearbox feet, the lower screws are 50 N, and the two large screws are 28 N

Shenjiao

Comparison between old and new

Throttle identification

throttle status

The intake seems necessary and needs cleaning.

Cover, tensioner

cover seal ring

replace the chain

Replace wheels, torque 90 N, tensioner 40 N

Timing aligned

Applying glue

apply glue

Cover installation reference sequence and torque

It’s dark and looks uncomfortable

It’s darker than 150 on the street

After the front end cover is cleaned

After the front end cover is cleaned

This gasket is universal to new and old models. The excess ring shape in the red area can be cut off without affecting use.