Replace the front water barrier rubber strip
LindaThackeray 
7 1 Pull out the entire strip from the drain outlet with your hand and remove it until it comes out of the skylight. There is no need to remove the entire strip.
2 Remove the adhesive strip with brute force, and don’t be afraid of damage.
3 Put it back, the bright strip on the paint surface is actually c-shaped, and there are snaps on both sides of the strip. There is also a limit groove on the front end of the bright strip corresponding to the buckle on the front end of the rubber strip.
4 Just use your fist to put the replaced hammer in.
About 5 were exchanged for a total of 232.8
2 Remove the adhesive strip with brute force, and don’t be afraid of damage.
3 Put it back, the bright strip on the paint surface is actually c-shaped, and there are snaps on both sides of the strip. There is also a limit groove on the front end of the bright strip corresponding to the buckle on the front end of the rubber strip.
4 Just use your fist to put the replaced hammer in.
About 5 were exchanged for a total of 232.8
Buckle it out
Get out, the lights are tough
ripped open
contrast
replace the
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
