[Big Player] DIY replace the left rear taillight assembly.

  12
 September 4, 2024
When the car turned on the left turn signal, the sound became rapid, indicating that there was a problem with one of the lights on the left. After checking, it was found that there was a problem with the rear taillights. So I placed an order for the corresponding model of left rear light assembly on a certain treasure and prepared to replace it myself.

The first time I demolished it, I didn’t know what tools I needed, so I just grabbed some tools and used them first.

Open the trunk

When I removed the plastic button of the decorative board, three screws leaked out. I used pliers to clamp it and rotate it a few times to screw the nuts off.

Get out the broken lights.

Take a closer look. If the light bulb of the car is broken, it will be easy to replace. You can take it out by rotating it

Remove all three replaceable light bulbs in the back. Take a look. I feel like all three are dead.

One was yellow like this, and the other was already white. The other one actually got water.

It’s too late

It turns white

This water directly entered the water. I really don’t understand how the water entered. Green moss has already grown on the lamp holder.

Here are 3 nuts, let’s take a close-up.

The car lights purchased by a certain treasure have arrived. Let’s compare them.

Look at the front, I saw that the shipment was damaged. Forget it, I don’t care.

Look on the other side.

We put the line speed into this hole first, and then put the three screws of the car light back into the original empty space.

This is the main connector. Connect the connector of the new car with the connector of the original car and it will be ok.

Put the plug in place, then tighten the nut, and you’re done.