Treating water leakage in the back seat of Bora, a detailed tutorial.

  5
 September 5, 2024
It’s leaking again.
This time it was the back seat, and the earliest one was the front seat driver’s position. I removed and replaced the seats, carpet and soundproof cotton of the entire car. This one leaked again. Let’s continue repairing it.
First, we found the leak location and removed everything that could be removed. Then we took a bottle of water and poured it down from the skylight position. We found it directly. The leak leaked from the B-pillar.

Remove the rear seat, lift the carpet, and pull out the sound-insulating cotton. My sound-insulating cotton was added later, with glue, which was difficult. The original car was recycled cotton, so it should be easy to take out.

Remove the trunk blanket and see the water guide pipe. This is where the water is flowing out. That plug must be pulled out and cleaned up.

Remove the roof, pull out the water guide pipe, and blow with your mouth. The blowing couldn’t be moved and the pipe was blocked. When removing the ceiling, remove the handle. Please note that Torx screws.

Trunk position, pull out the pipe, see? Clean it up.

cleaned up

I found the screws on the back lamp. I gained an unexpected reward. The screws here are gone, and now I have found them in this corner.

Look, unexpected gain

Let’s dry the removed soundproof cotton first. I will go back to the warehouse to look for it when I have time. I remember that there are new ones. If there are new ones, I will throw them away and replace them with new ones. This kind of thing will stink when it comes to water. If it doesn’t have it, I can only make do with it, and I have to dry it hard.
Don’t rush to press it first, but the carpet should be dried naturally for at least a week.

Recommended Suppliers