Used POLO Replacement Right Front Pull Rod Ball Head
CathyMark 
8 The Polo in 2009 has been more than 10 years old. The left front lever ball head has been replaced by itself, so the right front lever ball head has been paying attention to it. Recently, it was discovered that the rubber has become a little aging. Let’s take time to replace it, which costs tens of yuan, but it plays an important role at critical times, so such wearing parts personally don’t like dragging, so just replace them in time.
Although Polo in 2009 has been 10 years old, it has been served delicious and in good condition after receiving it.
Silver does not appear dirty or new, so it is more suitable for personal feelings at home.
This is the ball head that will be replaced. It costs tens of yuan and is not expensive.
Delunfo’s, original factory accessories, many accessories are from this brand.
Judging from the workmanship, it should be said that it is still good.
Remove the right front wheel and jack up the car.
Looking at the ball joint of the front right pull rod, the rubber parts have aged and cracked.
It can be clearer from this perspective. It should still be original parts. It can be replaced after 10 years.
In fact, when you think about it carefully, you can still continue to use it, but you will have to change it sooner or later, and replacing it early is not a bad thing.
Since it had not been disassembled for a long time, WD40 was sprayed on the screws for loosening and lubrication.
Loosen the screws directly.
According to the operation of the small repair shop, at this point, the hammer is served and knocked down directly.
Standardized operation and special fixtures can make the ball head fall off and reduce the impact of brute force operation.
Install the fixture and prepare to loosen it.
In fact, it is the principle of leverage. When the screws on one side are pushed in, the ball head on the other side is pushed out.
With a snap, the ball head fell off.
Then loosen the ball head, mark it, how many times.
Compare the old and new ball heads and see the differences.
The appearance is basically the same.
In fact, the rubber parts are aging and need to be replaced.
Conversely, screw it in and tighten the screws.
After the screws are tightened, a final reduction inspection is performed.
The inspection is complete and everything is restored.
Finally, use a torque wrench to tighten according to the specified torque.
Finally, use a torque wrench to tighten according to the specified torque.
OK, replacement completed.
I hope this rubber part will last longer.
Because it’s a friend’s store, we all know each other, which means to charge a fee.
In fact, it is not difficult to replace the ball head, and it is not a technical job. If you have tools, you can also exercise your hands-on skills.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
