Clean carbon deposits without removing, solve the problem of burning engine oil, mouse paste!
PhilFinn 
11 After a long hesitation, I still did it.
Current vehicle condition: 7 years, 100,000 kilometers, 5000 kilometers to replenish 1.5 liters of engine oil, the current oil level is close to the lower scale pit.
Overhauling the engine, the 4s shop is too expensive and expensive, and the outside shop feels unreliable.
A friend recommended that you do not need to disassemble the engine, clean carbon deposits, and solve the problem of burning oil. The store has made more than 20 units so far, and the results are very good. The cost is less than 3000 yuan. Let’s just be a guinea mouse for everyone. If the effect is good, please feel free to do it.
Current vehicle condition: 7 years, 100,000 kilometers, 5000 kilometers to replenish 1.5 liters of engine oil, the current oil level is close to the lower scale pit.
Overhauling the engine, the 4s shop is too expensive and expensive, and the outside shop feels unreliable.
A friend recommended that you do not need to disassemble the engine, clean carbon deposits, and solve the problem of burning oil. The store has made more than 20 units so far, and the results are very good. The cost is less than 3000 yuan. Let’s just be a guinea mouse for everyone. If the effect is good, please feel free to do it.
This is the cleaning agent that must be used. The white hand cream-like thing is an engine repair agent.
Before cleaning, the master first used an endoscope to check the condition in my cylinder to determine whether this plan was suitable. The results are: the cylinder wall is intact, the oil and gas separator is intact, the cylinder pressure is normal, etc., which meets the conditions.
During the inspection, I saw that the engine piston, the front and back of the valve were very heavily carbon deposited, and the fuel injection nozzle of the intake port was covered with carbon deposition. With the newly replaced spark plug, 5000 kilometers is already severely carbon deposited.
This solution has low material costs and mainly requires effort.
The master uses this large syringe to flush the cylinder back and forth every 10 minutes. The cleaning agent poured in quickly turned black. Then pull it out and replace it with a new one.
During the process, the crankshaft is also manually rotated to open the valve so that it can be cleaned to the back.
During the inspection, I saw that the engine piston, the front and back of the valve were very heavily carbon deposited, and the fuel injection nozzle of the intake port was covered with carbon deposition. With the newly replaced spark plug, 5000 kilometers is already severely carbon deposited.
This solution has low material costs and mainly requires effort.
The master uses this large syringe to flush the cylinder back and forth every 10 minutes. The cleaning agent poured in quickly turned black. Then pull it out and replace it with a new one.
During the process, the crankshaft is also manually rotated to open the valve so that it can be cleaned to the back.
During the soaking process, this equipment should also be used to heat the cleaning agent to maintain the temperature to achieve good cleaning effect.
From 9 a.m. to 8 p.m., it really takes a lot of effort. Finally, it is completed. This is to start the engine and use special cleaning oil (similar to engine oil) to comprehensively clean the entire engine. There will be a large amount of smoke removal and it will take 20 minutes to run.
The real effect will not be seen until actual use. Let’s wait and see, and I will release the actual oil consumption in a timely manner.
During maintenance in the store, I encountered a strange car that was faulty. It was a Zhejiang brand BMW X5. The drive shaft screws were not installed and fell off, breaking the gearbox housing. The oil leaked everywhere and it couldn’t be driven. Only then did I send it for repair. The estimated cost is tens of thousands of yuan!
The old Touareg next to it is so beautiful!
The old Touareg next to it is so beautiful!
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
