A great way to debug LED low beam with lens!

  4
 September 8, 2024
This time, it’s actually a bit uncertain, because I used to debug the high-beam of Silicon Core. There was no lens, and you could see the lamp bowl, which was more convenient to debug the angle. This time, I had to make a Civic with a lens, but I couldn’t see the reflective bowl. This is much more difficult

I’m in a good mood today and I’m not that busy. Hurry up and get it on, the low beam is too blind

Remove halogen

The replacement of old and new, traces of the times

Why would it cost 300 yuan for just a few lamp beads?

Install and fix the rectifier and wiring harness

This is a halogen lens effect before replacement

This is an LED effect. You can see the difference during the day. Can money buy everything?

Once you enter the basement, the effect is really terrible. Is this all it is? I have obsessive-compulsive disorder, haha, don’t be afraid, it will eventually be solved

Started debugging, but it was difficult because I couldn’t see the reflective bowl, so I could only try it many times to find experience

This angle doesn’t work. I tried it.

Final confirmation is a good angle

By the way, I also found a problem. The low beam of the Civic does not seem to be fixed very well. This LED is more obvious, so I added a rubber ring, and it is fixed very well. Let me like it

This is the effect. The power of wisdom. Low left and high right is the international standard for dipped beam lights, because they are afraid of hitting the opposite car!

This is a very close effect, you can see the superimposed effect, normal

Low left and high right is the international standard for dipped beam lights, because they are afraid of hitting the opposite car! This is the effect from 10 meters away. Not bad. I am really satisfied this time!

Recommended Suppliers