[17 Jialu Models] Change the oil machine, air filter, and clean the car at the gas station._vehicles, vehicles

[17 Jialu Models] Change the oil machine, air filter, and clean the car at the gas station.

September 8, 2024

Recently, the meter has always popped up. There are still hundreds of KM before the next maintenance ~~
It is a long way from the last maintenance in Jingdong. The experience I learned at that time finally came in handy, so I can do it myself!
Don’t say much and start working.

This community encountered a big brother model. The wheel is a bit bigger than me, so I also want to get 17-inch wheel hubs ~~~

Buy and prepare the goods. Various machine filters. Among them, I found that the workmanship of the Mahler is a bit rough, especially the size of the socket wrench at the end is a bit too large. Strictly speaking, the other models can adapt to the size of the wrench well, but the Mahler’s filter cannot be put in it. You have to tap it to stick the sleeve. I won’t buy the Mahler next time!!!
Machine filter brand: Hangster + Sofiema + Man + Lucas + Mahler (the workmanship is not good, so it is not recommended to buy it.)

Engine oil. Last time I bought five cans of engine oil at a discount on Jingdong, I actually found that 4 liters were enough. I only added 4 liters this time.
40 yuan/bottle x 5 bottles + promotional discount-20 The actual payment for the final 5 bottles is 176.96 yuan ~~

First of all, you must lie on the bottom of the car and remove this guard!! Plastic ~~ It’s a little hard!! 6 T20 screws +7 13mm outer hexagon

I use brackets to support the entire vehicle.

There are brackets on both sides.
Polo used to use a car repair ramp, but I found that the front of this car was a bit heavy and it was easy to drive over the head with the ramp. I have tried it once. So this time I adopted a more original plan.

Base plate: 6 T20 screws + 7 13mm screws.

Ratchet wrench +13mm socket.

Ratchet wrench +T20 socket.

Remove the oil screws, the waterproof tape made by Jingdong Maintenance before.

Cut one side of the original oil can to catch the oil.

Okay, the spacer for this screw has been used up and is completely deformed.

A hole has been broken.

Brand new screws and washers bought online, not from the original factory.

The removed air inlet box. There are two Phillips screws at the bottom of the box.

Blow it on and clean it up.

I forgot to take pictures during the refueling process ~~~ The whole process is relatively simple.
It was the Mahler I used first when installing the machine filter, so the sleeve of the Mahler did not work well!! Anyway, I won’t buy Mahler anymore!