The road to preparation of the 12th generation crown_vehicles, vehicles

The road to preparation of the 12th generation crown

JesseNahum

September 9, 2024

Post for the first time! Bikers just take a look! Don’t spit haha

The first thing to pick up the car is not to add fuel, but to change the wheel hub

Then the second thing is to change the lights. The original car lights no longer focus light, so driving at night is very dangerous!! The effect was immediate! But I forgot to take pictures

This is a photo taken at the vehicle management office after she finished modifying the wheel hub. It’s a little fishy.

Clean the engine compartment + wax!

This was taken at the butcher, installing a reversing radar!! By the way, an employee of the butcher looked too ugly to eat, so he charged me 50 for a small fog lamp bulb.

After installing the reversing radar, replace the fender lining + engine guard!

You have to have a set of chassis reinforcements. I didn’t take all of them.

After the chassis parts are installed, let’s dig for coal!

Carbon deposition is very serious!! Just brush it and it’s done

I’m not very good at the order of digging coal, so I’ll make do with it and see, hahahaha

Too unlucky. I don’t know who I messed with, but the sidewall was punctured with two small holes

Let’s continue to talk about preparation. The max10 generation ignition coil high-voltage package must be provided, which perfectly solves the problem of weak acceleration.