Engine compartment washing, cutting and blowing ~ cleaning and coating
YvonneSweet 
5 Cars in daily use with all kinds of road conditions, wind, sun and rain ~ the engine compartment is too dirty to see.
Some cars often open the engine hatch, a thick layer of soil, ah, everywhere accumulated a large amount of dirt
This not only affects the beauty of the engine cabin, but also affects the safety ah!
The dust and impurities entering the engine cabin will form dust and sludge on the engine surface. If they are not cleaned in time, the metal parts may rust, the plastic parts will age and deform, and the engine power and fuel consumption will increase.
A thick layer of ash affects the heat dissipation of the engine cabin, and in serious cases, the engine spontaneous combustion ~!
Some cars often open the engine hatch, a thick layer of soil, ah, everywhere accumulated a large amount of dirt
This not only affects the beauty of the engine cabin, but also affects the safety ah!
The dust and impurities entering the engine cabin will form dust and sludge on the engine surface. If they are not cleaned in time, the metal parts may rust, the plastic parts will age and deform, and the engine power and fuel consumption will increase.
A thick layer of ash affects the heat dissipation of the engine cabin, and in serious cases, the engine spontaneous combustion ~!
Cleaning is necessary ~ coating is also necessary ~ delaying the aging of plastics and pipelines ~!
Today, I came to the 4S store to clean and coat the engine. This project is a complimentary project and belongs to free cleaning. This is good. This project is also expensive to do outside, and there will be worries about improper operation, so it is very reassuring in the regular 4S store.
A total of three things should be used on the table, the pink cleaning agent and the green one are coated. After cleaning, wipe it off with a towel, and then you can coat it.
Both the cleaning agent spray pot and the coated spray pot should be connected to this elongated air pump tube, which can be sprayed out evenly under pressure.
The pink spray can also has a long mouth, which makes it easy to operate deep into the gap. The sound is not very loud.
The master of the workers was very skilled and quick in operation, and he sprayed it all up and down, left and right. The effect is obvious. The dust has been cleaned.
At the same time, the workers also use a dishcloth to clean the dead corner to facilitate the next step of coating.
There are too many irregularities in the engine compartment, with edges and corners, as well as dead corners. Wipe it clean and shiny!
Cleaning the engine cabin is not just a matter of surface kung fu, the depth under the engine cabin is so deep that you can’t get in with your hands and arms, and it can be easily solved with the help of lengthened nozzles.
The key point is below the engine cabin. I admire the workers who have cleaned it for a long time. I am really responsible for the free project for so long.
Below this is the intake grille, as well as the heat sink, which is more difficult to clean, but it is also meticulous to help. Thank you very much!
Engine cover, a layer of dust, after spraying cleaning agent, disintegrate sludge, after all, the dust in the engine cabin is relatively sticky. Even if you wipe it with a towel, you have to get rid of a towel. The towels can hardly be washed clean after wiping.
There may be oil stains next to the oil ruler to check the oil level, and the cleaning agent will be OK after spraying. This place is irregular, uneven and difficult to wipe!
Battery this place had better find professional cleaning, in case there is a short circuit, or there is a slight leakage, affecting the capacity of the battery will be depressed.
It is really convenient for nozzles to clean corners and corners. The workers are so patient and meticulous that they don’t let go of a dead corner.
Next began to coating the engine, this film plays a protective role, can protect the engine cabin plastic parts, prevent its aging and whitening and other phenomena, significantly improve the heat dissipation effect of the engine. For the lines and tubing in the engine room, effective nursing can prevent plastic aging and cracking, metal rust and dirt, and improve the life of the original components of the engine.
Little brother also pay attention to wipe off the stain before spraying, it’s too bad, so careful.
Clean the gap in the corner and then coat it with a film to prevent aging.
After the pipeline is sprayed up, it can prolong the life of the engine. Usually more maintenance, so that it will not be difficult to find defects.
Especially for the pipes in the cracks, the workers sprayed very carefully, very attentively, and very effectively.
The cleaning and coating is basically completed, and the work of the workers is basically finished. The effect is very good ~ the engine cabin has a matte color.
After hanging in the store for a while, I had something to go first and drove the air conditioner to the maximum. Although the cleaning and coating of the engine was tasteless, the ventilation was good.
Open the skylight for ventilation! That’s great! Thank you for the free engine cleaning and coating in the store.
After being washed, cut and blown by Brother Tony, the cabin has taken on a new look.
Meticulous operation, meticulous in place.
After being washed, cut and blown by Brother Tony, the cabin has taken on a new look.
Meticulous operation, meticulous in place.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
