[New Pattern] When you have nothing to do during the Spring Festival, replace the shock absorbers of the entire car yourself!_vehicles, vehicles

[New Pattern] When you have nothing to do during the Spring Festival, replace the shock absorbers of the entire car yourself!

September 12, 2024

During the Spring Festival holiday in 2021 AD, I couldn’t help but replace the shock absorbers of the entire car myself and the anti-roll bar glue. This operation lasted for two days in total and was purely a leisurely operation. This operation mainly solved boring days. Secondly, combining work and rest is beneficial to health. By the way, it saved at least 500 taels of silver. It can be said that it is worth praising.
Preparations:
1. Tools:
It is best to have two jacks, a pair of spring pulls, socket wrenches 13, 14, 15, 16, 17, 18, 20, a loose wrench, a 35cm socket extension rod, gloves, a self-paint can, and a steel brush for rust removal and dust removal.

remove tire

Note that this is a safety assurance action that must be paid attention to, so remember it.

front wheel

The spring puller can be twisted with a sleeve or a wrench. I use a sleeve.

The front wheel absorbs shock, and the removed rubber was not damaged but became hardened after aging. This is still the condition that it has only been used for three and a half years.

This operation must be used for the lower yoke position otherwise the shock absorber cannot be inserted.

front wheel

The front and rear wheels of this part are commonly operated, and attention must be paid to the installation carefully.

The front wheel and rear wheel have different structures and do not have to be operated like this

front wheel

rear wheel

When this glue ages, it will cause it to bend and sway. It will be good to change things that cost a few yuan each frequently.

rear wheel

There are two pull rings on the lower part of the rear seat cushion. Pull the upper seat cushion and the seat cushion will come down. Remove the fixing screws from the backrest and lift it up to remove the rear backrest. Then pull out half of the rear cover plate, pull out the taillight plug and completely pull out the cover plate.