Tips for picking and placing jacks 0_vehicles, vehicles

Tips for picking and placing jacks 0

September 17, 2024

The Datong on-board jack is placed in the pedal storage box under the passenger door. It does not take up the trunk space and will not cause bumps and noises due to its poor fixation. It is a very good design!
this is the place

Turn these two buttons in the direction shown on the panel to open and remove the cover

Inside is the jack. If placed normally, it should be tightly stuck inside from top to bottom.

How do I take it out? In fact, it’s very simple. Loosen this screw a little first.

The middle of the jack will be lowered until it is basically completely flat so that it can be easily removed

After taking it out, we looked at the fixed conditions inside. There is a sponge on the top and bottom of the original car, which can effectively prevent abnormal noises caused by friction between the jack and the car body during bumps. It is very user-friendly!

When putting it back after use, loosen the screw of the jack first, lower the middle completely, and then put it in.

When putting it in, pay attention to aligning the bottom of the jack with the sponge, and then start tightening the screws. The middle of the jack will rise until it holds the sponge above.

The screws should be tightened slightly to make sure that the jack can be fixed. When it is not firmly placed and fixed, it will cause abnormal noise.