Second-hand POLO Replacement Engine Three-piece Set Regularly Replacement without procrastination_vehicles, vehicles

Second-hand POLO Replacement Engine Three-piece Set Regularly Replacement without procrastination

September 17, 2024

The weather is cold now. When the cold car is started in the morning, the engine squeaks violently, but the hot car does not. I know that the belt is aging. After thinking about it, I haven’t replaced this car since taking over. Considering better use in the future, don’t drag it, replace it in time. If you want to replace it, replace it comprehensively, and replace it with the three-piece set together.

After thinking about it again and again, I didn’t do it myself. It might be difficult to operate without a lift, so I came to a familiar store.

The accessories you bring are all authentic from the original factory. This is a tightening wheel.

Flexible rotation and small clearance.

The master had already gathered around and was ready to start work.

The location is not large, so turn on a light to operate.

The master lifted the roof of the car and checked from below how to replace it.

Remove the belt first with three or two clicks.

The belt that has been running for hundreds of thousands of yuan is a little aging.

Small cracks are inevitable.

The whole thing is hard, so I can continue to use it, but I don’t want to anymore.

The new belt is soft and tough.

There are no cracks.

Taking advantage of the opportunity, I checked the gap between each wheel and found that it was not large and did not need to be replaced yet.

I was preparing to dismantle the tightening wheel. The master took a look and found that it should start from the top.

Then come from above. The location is very small and the small flying board is not easy to operate.

But it was quickly removed. The old tensioner wheels were no longer very flexible.

Continue tearing down and cross the ferry.

This is relatively simple, and it will be removed quickly, leaving an empty hole.

The key points for dismantling the ferry can actually be separated and not integrated.

The wheels and screws can be separated, so don’t lift the engine to clear the gap.

Install the tensioner wheel quickly and tighten the corresponding screws on the back.

After separating the tensioner, screw in the threads.

Then slowly tighten it.

Finally, everything was installed in place.

Finally install the belt and wind it in the original order.

After winding the belt, you need to take out the tensioner wheel to fix the screw, so that the tensioner wheel will pop out and tighten the belt. Therefore, a master turns the tensioner wheel in the opposite direction on it, and a master pulls out the fixing screw.