The seat belt buckle clings, don’t be afraid, watch me teach you a permanent solution in a few minutes.
BradleyBenjamin 
12 The car has been driving for three years, and it is not bad in all aspects. During this period, the main driver’s seat belt buckle sounds like a clatter. Any small hole you walk into will be clatter. I can’t stand it anymore. It has been a long time. The plastic parts are aging and the gaps are getting big. Okay, forgive you and start to solve you permanently by yourself. Here is how to do it. It’s very simple
It’s right here where the seat belt is put. The sound is so sour and clattering.
Holding this part with your hand, it shook up and down. The gap was very large, clattering, and it was very loud, mainly due to aging.
Just press it and go in about 3 millimeters immediately. Did you say it wouldn’t make a noise when it was stuck?
Compare the position of this picture with the picture below
Watch the large spacing, it is at least 5 mm from top to bottom
Remove the B-pillar
Pull the pimp off first
Break it out from the ceiling position and there are two buckles on it
If you break the bottom side out, there are also two buckles
Just break it like this
You can break off the top. There are a total of 4 buckles on it
Remove the skateboard that made an abnormal collision sound. The main abnormal sound location is that the six buckles stuck on the skateboard, and then the gap becomes large, making a collision sound with the skateboard
The upper and lower parts are also the source of abnormal noises. They will be dealt with together later. You see, it is the place where he pasted the nonwoven fabric. There are too few stickers on the original car
My solution is to use insulating tape to prevent the two pieces of plastic from making a collision sound
Six buckles and upper and lower parts are pasted
completed
Just put the skateboard on and tried it on and it was tight
Pay attention when installing, first connect the three buckles here to the upper plastic plate, then install the lower part, and finally install the upper plastic plate
It’s finished, and there’s no gap between fingers. It’s very tight
Be careful not to expose the insulating glue when you apply it, otherwise it will be too ugly
After the project was completed, I went out to try it out, and it was solved perfectly. If there were abnormal noises from the riders, you can get rid of it once and for all
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
