[Flower Pepper Car Maintenance] Mercedes-Benz smart clutch replacement three-piece set with slipping clutch

  5
 September 17, 2024

One smart machine of 10 W-kilometers in 2009, and a three-piece set was replaced when the clutch failed.

The clutch slipped and it was difficult to change gears. Replace the three-piece set.

Three-piece clutch set: Including clutch pressure plate, clutch driven plate, clutch release bearing clutch (pressure plate, disk, release bearing).
It is manifested by failure of gear engagement, slow response to gear engagement, failure to move, stiff gear switching, and failure to start when restarting after a fault. They are all manifestations of common faults and problems with the gearbox of this smart Mercedes-Benz mini car.
Smart rear engine

The clutch is located in the flywheel housing between the engine and the gearbox. The clutch assembly is fixed on the rear plane of the flywheel with screws. The output shaft of the clutch is the input shaft of the gearbox. While the car is driving, the driver can step on or release the clutch pedal as needed to temporarily separate and gradually engage the engine and the transmission to cut off or transfer the power input from the engine to the transmission.
After the gearbox was removed. The clutch discs come out.

The technician disassembled the transmission assembly. After the assembly was removed, he inspected the clutch and found that the clutch was severely worn to the point where the internal parts were severely strained.
The pressure plate is also severely worn


In the end, due to the severe wear of the clutch, the clutch had to be replaced with a new clutch to solve the above faults caused by clutch damage. After installing a new clutch, the fault was eliminated, and the owner inspected the vehicle to confirm that there was no fault before delivering the vehicle.

Recommended Suppliers