The POLO car has been around for more than 7 years, but the rear shock absorber glue has aged and broken. The Taobao parts have been replaced by themselves
The POLO car has been around for more than 7 years. The rear shock absorber glue has aged and broken. The Taobao parts have been replaced by itself. It takes 2 hours to complete it by one person, and he has to take a selfie.
The fault light on the stopwatch came on, so I went to the repair shop to check it. The rear wheel sensor was broken. When replacing the ABS sensor, I found that the two rear shock absorber rubbers were aging and broken. Taobao accessories replaced them themselves.
The car is more than 7 years old, and the rear shock absorber glue has aged and broken
The new suspension glue is not made in Germany, but the quality looks good
I wonder if it’s German?
Prepare tools, three jacks, 16mm sockets, and wrenches
Prepare tools, three jacks, 16mm sockets, and wrenches, and start work
Prepare tools, three jacks, 16mm sockets, and wrenches
Prepare tools, three jacks, 16mm sockets, wrenches, various tools
Everything is complete, start construction, use 2 jacks, safe and assured
Use 2 jacks for safety and peace of mind
Use 2 jacks for safety and peace of mind
Remove the rear wheel first, remove the upper screws first, and then remove the lower screws.
The lower screws are also 16 mm. Remove the upper screws first, and then remove the lower screws.
Remove the upper screws first, then remove the lower screws, and come down
down
The shock absorber does not leak oil and can continue to be used without replacement
Use two tools to remove the fixing screws and install the rubber sleeve again
Use two tools to remove the fixing screws and install the rubber sleeve again
Use two tools to remove the fixing screws and install the rubber sleeve again
When installing it, install the upper fixing screws first, and then install the lower screws. Use the jack if the hole is not aligned.
Install the screws below, but the holes cannot be aligned. Use the jack.
Install the screws below, but the holes cannot be aligned. Use the jack.
The shock absorber is manufactured in 8 years
No oil leaks, can be used as needed, and can continue to be used for another 5 years
When installing it, first install the fixing screws on it,
finished
Compare the two gums, the old one is of German origin
The old one is made in Germany, and now the new car will not be available
Group photo taken with 2 replaced suspension glue
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024
Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024
You May Like