2016 classic Xuanyi manual replacement of shock-absorbing top glue process_vehicles, vehicles

2016 classic Xuanyi manual replacement of shock-absorbing top glue process

September 20, 2024

First of all, I don’t recommend that motorists replace the top glue themselves, because it is too complicated, tiring, and a waste of time, and it is also dangerous.
This post wants to let the repair shop master understand the structure of Xiajingxuan.
I replaced it myself because I thought it was not difficult and easy before replacing it. It could also solve the problem of noisy noises in front of the car crossing the gravel road. I never thought it would be so troublesome.
The most annoying thing is that my original top glue is not broken, and the abnormal sound is not caused by the top glue, but the car has traveled 106,000 kilometers. I bought all the new ones and replaced them. Although I didn’t solve the abnormal noise, my tools and practical experience prepared me for replacing shock absorbers and other parts in the future. There was an incident. When removing the bolts, I found that the tool I had prepared in advance was of the wrong size.
Because I couldn’t find the bolt specifications of Xuanyi shock-absorbing components on the Internet, I only read the tutorials of Trent and Conway. I thought they were both Nissan, and the bolts should all be the same, but in fact they are different.
I had to walk to the hardware store on the street to buy wrenches. I bought them twice! Because a 14 bolt position was not easy to use, the wrench was twisted! Time is wasted here.
What you want to say below is written in the picture.

Lift up the jack, remove the tire and place it under the car to prevent the car from tipping over. A jack is not safe.
Rust remover had been sprayed on each bolt the day before and sprayed again before unloading. The bolt is difficult to twist. the tools are all purchased online.

Too much rust remover was sprayed.

This tool is not very easy to use, only one hook is completely hooked, not exactly round. Make sure this thing is hooked properly, the spring will hurt people if it breaks out. I check if the hook is disengaged every time I twist the bolt a few times while pressing the spring.

It’s one o’clock in the afternoon, I went to a nearby restaurant for dinner, and came back to take a picture of the park scenery. Don’t underestimate the two residential buildings in the distance, each square meter is 40,000 to 50,000 yuan. haha

I was quite surprised. I opened the Jingxuan steering plane pressure bearing and found that it was made of pure plastic. There was no steel ball in the middle. There was grease between the two pieces of plastic. When they were put together, they rotated like this.

There are three bolts around the cabin roof glue, one of which needs to be lifted off the round plastic button under the wiper. It can be screwed off with a long handle and a sleeve. There is no need to remove the wiper and plate.