Sharp world replacement wiper rubber strip_vehicles, vehicles

Sharp world replacement wiper rubber strip

September 23, 2024

Sharp has been buying it for more than 4 years, and the wiper strips have aged. I replaced it with a pair of Bosch ones in the 4s, but it was a little jumpy to use. I bought the strips online and tried to put them on myself.

The wiper in the new world is as long as left and right, and the only tool used is a paper cutter.

The wiper has sealing caps at both ends and two clips on each side in the middle.

In the middle is the fixing bracket

Start removing the old adhesive tape and directly use the blade to scratch it along the iron sheet.

Violent dismantling

When it was removed, there were two iron pieces.

Squeeze the iron bars together with one hand and pull out the hat with the other.

The way it’s pulled out.

Remove the adhesive tape and make it easy to remove the clip in the middle.

Remove all of them, pay attention to the slope of one side of the clip, and don’t install it in the wrong direction.

Can be completely separated

The iron bar and the large clip in the middle have a buckle, which must be aligned when installing.

Put it aside first.

Stuck in the middle, first lane from the right.

Putting it on one side.

The most critical step is to pass the iron bar on the other side through the gap in the adhesive strip and the track buckled in the middle, and push it forward along the track to the end.