VW Golf6 Variant rear shock absorber damping sleeve replacement
SibylBessie 
7 The shock-absorbing rubber sleeve here is a wearing part, so it needs to be replaced if it breaks.
Buy parts here, a treasure, original German parts
Since it is a wearing part, it looks like the original factory has no identification ability, so just get on the bus.
Buy parts here, a treasure, original German parts
Since it is a wearing part, it looks like the original factory has no identification ability, so just get on the bus.
As you can see in the picture, the shock-absorbing rubber sleeve has already appeared in two sections.
Pad the body with stones and use soft materials where it comes into direct contact with the body to avoid damaging the paint.
Pad the body with stones and use soft materials where it comes into direct contact with the body to avoid damaging the paint.
Wash all the inside of the wheel arch quickly
Wash all the inside of the wheel arch quickly
Remove the two bolts here
Tightening torque here during installation is 50NM
Tightening torque here during installation is 50NM
You don’t need to remove it here, just remove the top two bolts.
If removed, tightening torque is 130NM
If removed, tightening torque is 130NM
Dedicated dismantling tool, available in a treasure
You can install it without removing it here
The top can be removed directly on the body
The top can be removed directly on the body
Since you remove it and wash the wheel hub, use iron powder remover here.
Installation is complete.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
