2017 Dajiu replaced rear wiper rubber strip
ChanningGrey 
10 The original car wiper has been used for almost two years, but it has been difficult to use recently. I originally wanted to replace it with a boneless blade, but the original wiper holder was still good, so I decided to only replace the rubber strips. There are posts on the Internet about replacing the front wiper strips, so I won’t post it here. The rear wiper is different from the front wiper. Send one, hoping it will be useful to everyone.
Pull the rear wiper rocker arm open. The wiper is stuck on the rocker arm. Use a screwdriver to pry at the two red circles and take out the wiper. It is not easy to pull it off directly. Be careful not to damage the buckle when prying.
The way the buckle looks
Insert with a utility knife and cut back
Just cut off part of the adhesive tape, cut off the back, and then pull it out from the glass contact surface. The back must be cut off, otherwise it will not be pulled out.
The adhesive tape purchased by a certain treasure must have the wrong size and needs to be cut
After removing the rubber strip, squeeze the steel sheet hard and pull out the rubber cap
Reinstall new adhesive strips along one end
The rubber strip is elastic. After installing it, press it inward for a certain distance, then pinch the top of the steel strip and install the rubber cap back.
Finally, just install the wiper blade back on the rocker arm. After removing the adhesive tape, be careful not to remove the steel bar from the middle Song position, otherwise the adhesive tape will not be installed.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
