Some time ago, a tire pressure test was installed, which was installed directly in the rightmost blind hole. Later, I found that I couldn’t help looking at it while driving, but the steering wheel hindered the line of sight, so I made a decision. I intend to change the tire pressure monitoring monitor and the radar switch to another position. We’re in trouble.
This is the starting position, this position, the phone button on the lower left of the steering wheel just blocks the tire pressure test, if you want to take a look, you need to tilt your head very much, affecting the safety of driving, and the position of the radar switch, I only need to squint to see it.
If you open the small panel, you don’t have to talk about it. Old people all know it. Just point to Zen.
~
Here comes the point! After removing the small panel, when removing the two switches from the panel, be sure to note that the radar switch should be poked out from the wire harness to the outside of the small panel, do not hold the button of the radar switch to pull out, otherwise it is very easy to damage!
In the circle, the small clip of the button, because of my wrong operation, was pulled off by me, and as a result of my pull, the whole switch of the radar failed, which is explained in detail below.
It is right to push in the direction of the arrow. Never pull the button.
Use your fingers against the white part!
If only it came out, it would be good, Tmurt
When you press this radar switch button, the button clicks, and then the electronic sound “ticks”, the radar green light on the button is on, and the radar works; click again, the radar green light goes out, and the radar stops working. After I decomposed the switch, I found that there was a small bulge made of plastic inside the switch. When I pressed it, the green light was always on, and when I pressed it, I took it off and the green light went out. The position of the bulge is in the position shown in this red circle.
The structure in the circle, because I forced to pull the button, was broken, resulting in the failure of the switch, can not power on for a long time.
I forced to pull the button, causing the small bulge to break, and the radar switch could not hang up no matter how much it was pressed, so the symptom was to press the radar switch and the radar would work normally. As long as I let go, the radar would not work. Hand debt, hand debt.
Had no choice but to buy Taobao to buy a new switch, the shopkeeper said it is Guangben switch, but all can be universal, I placed an order. After receiving it, I found that it was wrong, although it looked the same, but Guangben’s radar switch did not click. After it was installed, it was normal to press and hold it. I couldn’t let go of it. I really lost confidence. I went directly to Dongben 4S store with the old and new switch. The maintenance master looked at it and said that the switch I bought should not match, so I set a switch in the 4S store and said that the goods would arrive two days later.
This is the arrival of the new switch, after installation, sure enough, with a click, the radar light is always on, the radar is working normally, replace the new and the old, let’s take a picture.
When the new radar switch arrives, take it out of the warehouse, unpack it, install it, turn it on, drop it, damn it, 2 minutes and 40 seconds in total. Then the after-sales buddy who accompanied him looked disdainful.
Took a look at me, said coldly: material fee 117, please pay. I asked carefully: the man-hour fee.
The buddy pointed to the financial door and said: get out. I said: Oh
All right, jokes aside, I’m very satisfied with Dongben’s warm service. I really do.
In addition, there is a small thing. The green light on my radar switch should be burned. I bought led beads on the Internet and found that it was wrong. So when you buy it, you must check with the shopkeeper. I bought this house, although the picture is the same as my old lamp beads, but after the arrival of the goods, I found that it was wrong, so I returned it. Fortunately, I bought the freight insurance. Otherwise, if the lamp beads are only 15 yuan, the freight will be 10 yuan.
The white one is the original, burned, and the green one is the newly bought LED lamp beads. The size of the base is different.
White is the original.
Well, to sum up, it is a good thing to like hands-on operation, but when operating, you should be more careful, understand the principle, and do not use brute force. In addition, although the accessories of Toshimoto and Hiroto look similar, they may be different in some minor details, such as this switch.
The above, I hope you like, have more experience to exchange ha, 09 Platinum is also a 10-year-old model after all, some small details, may not be able to find information online, so if I encounter any problems, I solve it myself, I will send out, and let other riders take fewer detours. My radar switch arrived, and when I went to the 4S store for the second time, after I finished, I pointed to a black car that had been crashed in front of a distant shelf and said, “your car is so well protected. Do you see that one? it’s also a Spielui. We can see that this is a car that bought a car and crashed the insurance fraud.” I was surprised at that time, and this kind of operation? The elder brother said that the car parts are expensive. I remember that at that time, the sales volume of Spencer was not very good, and the total quantity was also on the low side. Now one is broken and one is missing. I hope everyone will cherish their car and let it accompany you.
Take a picture with the setting sun, it’s good.