Remove the clouds and see the sky-cleaning the front and rear wipers_vehicles, vehicles

Remove the clouds and see the sky-cleaning the front and rear wipers

September 25, 2024

For example, the wiper of a car is like a person’s eyelashes and eyelashes, protecting the retina, thus ensuring that your line of sight is always clear and clear, and the wiper is the same. It can always keep the front and rear of the car clear, broaden your field of vision and ensure the safety of driving. Therefore, the wiper is an indispensable safety artifact of a car, and it is also the most easily worn accessory of a car. if you do not pay attention to maintenance, the service life will be very short, at least a few months; on the contrary, if you pay attention to maintenance at ordinary times, it can also greatly increase its service life, mostly in years. I have heard of a car friend who has been in use for 3 years. I think this has a lot to do with the maintenance of car friends.
Today, let’s talk about the easiest way to maintain wipers that almost anyone can do: cleaning regularly.
First show the tools you need to clean wipers: discarded toothbrushes, towels, hand sanitizers, sponges, wiper repairers, cleaning gloss, etc.

Let’s talk about the specific steps of wiper cleaning with cyclists:
First, remove the wiper strip from the car.
1. First, put the wiper in the maintenance state, by rotating the car key to the ACC (power supply) state (reminder: there is no need to start the engine), and then poking down the right wiper lever under the steering wheel once, you will see the front two wipers stand up, so it is easy for you to disassemble.

In order to prevent damage to the glass, it is best to put a towel on the front block (changing the front shield will cost at least 700 dollars in the 4s store, and the loss will outweigh the gain).

Isn’t this safer? it’s always useful to be on guard, in case something happens.
2. Remove the wiper strip, hold the square button on the wiper handle with your thumb or key, press it down hard, and hold the wiper outward with the other hand. There is no technical difficulty, do not use too much force, so as to avoid the deformation of the steel plate in the wiper.

This is the state of the wiper strip coming out.

This is a completely taken-out scene.

In the same way, remove another wiper strip from the front block and remove the twigs from the front block so as not to block the drain hole.

The rear wiper is relatively short and easy to unload. Put the wiper handle up directly, press the control button and pull it out again by pressing the chute.

This is the removal of the three wipers, look carefully at the rubber blade is indeed damaged, this is why the wiper scraping is the front block with curved water marks, this is the most important reason for me to clean the wipers today.

Second, clean and maintain the wiper strip, first use the wiper repair device to repair the slight defect on the wiper rubber strip, note: in the repair is to bring water slowly back and forth, moderate strength. In fact, it is consistent with the principle of fine sandpaper polishing.

This is the real body of the restorer.

Press the arrow to open it, and you will see the core equipment: metal polishing piece

This is a relatively thick metal polishing piece.

Choose the blue one, which is the finer metal sand surface.

This is the process of installing fine sand for the repair. it is very simple, just make sure that the coarse and fine sand has been prepared inside, and then press the arrow on the cover to push it backwards.

This is polishing and repairing both ends.

Carefully polish each wiper strip (note: be sure to bring water to work, dry wipe is not allowed)
Third, rinse the wiper strip with clean water, you can add an appropriate amount of hand sanitizer and other neutral detergent in the clear water, so that it will not cause harm to the rubber strip.

Carefully brush all the rubber strips with a prepared toothbrush, and then rinse the wiper strips with clean water.

Put it under the faucet and rinse with clean water, then wipe it off with a dry towel.
Finally, treat the three wiper strips with a clean and smooth agent.

Apply a cleaning gloss to the sponge

Press the rubber strip with your hand and wipe it back and forth.

This is the oil film and rubber powder wiped down, and the effect is really good.

Then wipe the three wiper strips with a towel, and the wiper strip cleaning is over.

This is a completely washed wiper strip to see if it is the same as the new one. How effective is it? Let’s take a look at the use effect below.
Fifth, re-install and use, the effect is much better than before, very satisfied with this cleaning, although tired, but have a sense of achievement, as exercise, a word: “value”!