I never looked behind the car. I accidentally found that one of the license plates lights was not working on one night in May. One day, I flicked the shell with my finger and it lit up again. I guess the contact was not good, and the lamp housing was still full of soil. These phenomena were abnormal. The lamp has been used for 14 years. Let’s remove it and see if it can be wiped for maintenance. Plastic parts will break when they age and become brittle. After taking it apart, it was not bad. One was intact and the other was cracked (the circle in the picture). Just fill the gaps with elastic glue so that it can bounce up and jam the sheet metal when it is installed in the car. Not worth buying a new one. The sponge sealing gasket of the original car has been rotten and will cause water and soil. It needs to be remade. It is an extra two millimeters thick and a one-meter EPDM EPDM foamed rubber strip is purchased for the postage stamp. It is similar to the material of the door sealing strip. It has a long life and good elasticity. Wipe the two lamp housings and re-make the sealing gasket. The connector is gently polished with 800-mesh sandpaper to ensure good contact, and the deformed position is slightly adjusted. The original car light bulb is Toshiba’s brand. It has been used for 14 years. When changing two light bulb positions, one of the light bulbs always failed to light up, so I simply changed it. It didn’t feel real online. It was bought by OSRAM from Jingdong. After loading the car several times at night, it was still lit. Comparing the opening length of the actual object with the sheet metal on the vehicle, it was found that the picture of the maintenance data was wrong. But the disassembly method is correct. Move the headlight up and down to prevent the gasket from adhering, and then push it gently to the left, and the right side will fall off first.
The annual inspection in August is too hot. Please do it in advance today. All projects such as exhaust gas are passed at one time, which is expensive 320. The mobile phone holder was also broken. I made one randomly and there was a photo. Half a year ago, it was discovered that the glass kettle was leaking and the wiper motor was not tightly sealed. More than 30 of them were replaced with domestic ones. The effect was good, but the imported ones were too expensive.