Hello, everyone, this time there are two main things. One is to replace a battery power cut switch, and the other is to replace the hydraulic support rod of the engine cover. Not much nonsense, the picture above!
The battery power-off switch makes it easy to remove the negative pole if you don’t use the car for a long time to prevent the battery from losing power.
I originally installed one, but the shape is not very good and it is not too convenient to use. The position of this switch knob is designed to be more suitable for me and it is relatively convenient to use.
Put this end on the battery negative pole
Comparison of old and new power-off switches
This opening is a little big and feels loose when it is put on, so I tied a cable tie and fixed it.
Engine cover hydraulic support rod. This thing has been around for many years, but because it is a dispensable thing to me, I have never installed it. I vaguely remember that the design of this thing seemed a bit complicated and it was not very convenient to install. It has been too long to remember. Anyway, the installation position of the hydraulic rod is now very convenient and the installation is very simple.
Remove the original car screws here
Replace the special screws for the hydraulic rod
The same goes for the other side
Remove the screws at the bottom of the cover and put on the hydraulic rod fixing gasket.
gasket
This end fits directly on the screw post
Use screws to fix it to the gasket here
Done. The one I bought was relatively cheap, the quality was very average, and the journey was not very long. It probably took half way to open the cover before it could automatically rise, but it was much better than nothing. The cabin is a little dirty, haha.
This is taken during the last maintenance of the vehicle, replacing the gasoline filter.
This is to replace a steering column rubber plumx pad steering gear. After this object wears to a certain extent, the steering wheel will make an abnormal sound. Many auto repair shops will let you directly replace the steering column assembly. The price is not low. I also found out after consulting many places that the culprit is this thing. There is no need to replace any assembly at all!
It’s this little thing that’s been worn out.
The abnormal noise of the new original parts was solved smoothly after replacement. The thing is worthless. The main reason is that the labor is relatively expensive. It is a bit difficult to replace this thing. After I finished talking here, I spent 150 yuan.
This is replacing the crankshaft position sensor. The original car broke down, causing my car to have various problems such as throttle failure, occasional brake failure, abnormal noise, etc. To be honest, I don’t know if it was all because of him, but after the replacement, all problems disappeared! When the problem first occurred, I didn’t know where it was broken. Through computer testing, it was found that this thing was broken. After replacing it, it was all normal!
This is the replaced crankshaft position sensor! The End!
LeoBruce 
6 
September 3, 2024 
