The foot mat installation operation is no longer dirty!!!

  8
 September 5, 2024
Dear drivers, happy New Year ~
Recently, I discovered that although the original floor mats that I bought for a car are of good quality, they are a little resistant to dirt, so I planned to replace them with one that surrounds better and collect them from the original factory to replace them ~~
So I looked everywhere for suitable floor mats, and I also looked at them all. They were not obedient, they were difficult to install and tear down. The cheaper ones were not of good quality, and the expensive ones were not worth it. They felt that they were being strongly advocated by the manufacturers.
Thanks to the motorists in the motorists group for their recommendation, I finally chose a detachable wire loop foot pad. I suggest that everyone also use wire loop foot pads. The wire loop foot pads not only feel comfortable, but also have almost no odor. The key is also fire-proof and flame-proof.
In the past two days, I have obtained a certain treasure and am ready to install it myself. Also check to see if it fits as explained.

It can be seen that the quality and workmanship of the original factory foot mats are still very good. Maybe the quality is too good, and a little muddy water will make it dirty.

In the driver’s seat, I went up and tried stepping on it a few times, but everyone ignored the dirty footprints. The wire ring mat in the picture can be removed separately. Remove and wash it from the circle.

The steering wheel linkage is also well reserved

Co-pilot’s seat, this position is easier to explain how to fit

The first thing is that there are a lot of these snaps on the foot mats

The positions are correct and inserted directly into the corresponding vehicle gap.

Press again

It will fit very well

The same goes for the back row.

Adjust the front seats to the front

Be careful not to block the air outlet

Stuff the middle part into the cushion

Completed ~~

Welcome everyone to join ~~

Recommended Suppliers