Although it has been updated several times one after another, it does not include a method to replace the air conditioning filter element (that is, the air conditioning compartment). Let’s open a special post here to explain it:

Although the title is called being kind to the bumblebee, in fact, for the matter of air-conditioning compartments, it should be for all riders to treat themselves well, because the air filtered by the air-conditioning compartments is in direct contact with people. If it is not replaced for a long time, it will be very dirty… It is always bad for your health. Not only does it not achieve the purpose of filtering the dirty air from the outside world, it also harms you.

The following is a picture to illustrate the operation method. It is very simple. When replacing the filter element, my car traveled 7,000 kilometers. You can compare and see how dirty it is:

First open the cover, find this position, and lift up the rubber strip. The air conditioning compartment is below here:

You can see the edge of the filter element, with a circle of sponge on the edge.

Here’s why I didn’t use the original filter element-because it was cheap! This thing with no technological content can be used by the subsidiary factory without spending money. I bought this in Jingdong.

Of course, the higher-end air conditioning compartments are equipped with activated carbon (it’s not so white, and the top is black), but the ones with activated carbon are more expensive. You can find them yourself if you need them. At least I didn’t directly find the air conditioning compartments with activated carbon of the exact same size used by Camaro. You can let me know if you find them. But in fact, it doesn’t matter, as long as you change frequently, it’s better than anything!

It was obviously upside down when I opened it in front of me! But why the opposite? Think about it carefully, it was 4800 kilometers away. When I went to the 4S for maintenance, the 4S once took this air conditioner out to blow (it was not dirty enough to be replaced at that time), but later I put it back and installed it upside down!! What level!!

The correct installation method is to install it along the air and point the arrow inward, but the arrow is on the bottom side, so the arrow will not be visible after installing it. But it can be seen that the circle of the sponge should be inward so that it can be sealed well.