Fu San replaces the outer door handle
AlexiaDora 
8 Xiaofu has been my car for nearly six years and has provided a lot of convenience. But recently, when I opened the door, I always forgot to press the door button and lock it, so I pulled the handle to open the door. It only happened three times. An accident happened. When I picked up the children from school at night, I went late. When I opened the door urgently, I forgot to unlock it. The right front door handle was broken, and my heart was cold.
During the period when Second Brother brought soaring prices, he would save on his meager salary if he could. Buy a handle on a certain treasure and immediately roll up his sleeves to replace it.
During the period when Second Brother brought soaring prices, he would save on his meager salary if he could. Buy a handle on a certain treasure and immediately roll up his sleeves to replace it.
The door handle broke like this
Thinking that this point should be fixed with screws
Sure enough, when the rubber plug was pried open, the bolt leaked out
This point should also be there
It was too violent accidentally, and the corners were pried and there were traces
Try opening this too
After the decorative sheet is pushed open with a small screwdriver, the true appearance of the fixing screw is revealed
After observing the inner door panel, there were no traces to prove that there were fixing bolts. When I started lifting the door cover, I had to open this first. I moved it hard and it really opened.
Now you can start tearing it down
Gently open the inner door armrest groove and remove the cord insertion groove
Gently open it a little more and observe it. There should be no problem.
It has been broken. Try to remove the inner door handle cord. Pay attention to the cord number and make no mistake during installation.
To see the true appearance of the inner panel after being removed, tear off a little protective film and study how to remove it when replacing the door handle
This should be the fixing bolt on the other side of the outer door handle
Loosen the nut and remove the damaged handle smoothly
Try taking out the door lock. There is a connecting rod for the door lock. Turn the plastic buckle in one direction and pull out the connecting rod. Note: The plastic buckle cannot be taken out.
Not bad, the original lock body is still made of iron
Bought from a treasure, plastic parts
The overall picture of a treasure purchased
After thinking about it, I replaced the lock cylinder with a new handle on a certain treasure
It couldn’t be installed during the final installation. It took an hour to disassemble it. First, install the lock body, fix a bolt, and then install the handle. The installation was restored step by step. It took another half an hour to install it.
You’re done. Lock and open with the key. Lock and lock with the remote control. Try opening. It’s normal.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
