Solve the problem of poor steering wheel feel-sewing leather handles
MaxwellNahum 
11 The place I touched the most when driving was the steering wheel. I didn’t pay attention to it at first, but the Xiaoke Premium version was not a leather steering wheel. The feel was really unflattering. It was hard and uncomfortable, and I didn’t like that kind of handle set. I decided to use a sewing leather handle set for special vehicles. I chose many companies and liked this one. The evaluation was not bad, and the actual effect was also good. The best thing was the sewing craftsmanship.
First, I will take a beautiful photo of Xiao Ke. The more I look at it, the better I look at it. The body lines are just beautiful, and the design of the waist line is my favorite. It is tough and handsome, and the whole side has a very strong sense of layering.
Let’s first upload a finished product drawing to let everyone see how the effect is and find fault with it. Anyway, I didn’t pick it out. The feel is much stronger than before, the comfort is very good, and it is no longer slipping. I would like to praise it.
The packaging is quite exquisite, and it also specifically says it is dedicated to 4S. Now this can’t fool people.
The tools sent inside are quite complete, including double-sided tape, thread, and small scrapers. The amount of thread is sufficient.
The leather of the handle cover is good. The top layer is very thick and feels good.
I specially asked for help from an expert. I first put the condom on the steering wheel and the position should be correct. Don’t make the mistake, otherwise it will be troublesome.
Double-sided adhesive tape was also adhered at first, but during the actual sewing process, there was a problem. It stuck to the holster, which made it difficult to tighten, and later it disappeared again.
Pay attention to the place where you put the needle. Put the needle at the seam of the holster and sew it to both sides. This can ensure that the seam is well sewn and affect the appearance.
It is best to use a lighter to burn the thread when taking up the wire to prevent it from falling off. This is very important and must be done well.
Now that we have finished sewing a piece, let’s see how to do it and see if it is technical.
For the convenience of operation, adjust the steering wheel position. At this time, you must drive the car, otherwise you will not be able to steer.
After sewing, it is time to carry out edging work. Don’t rush this. Use the scraper supplied. It is just right. Operate slowly to avoid damaging the leather case.
The following methods are basically the same.
It’s all completed and looked at the details. Is it perfect? It’s just that the place below can’t be padded and is a little open. It’s the only way. There’s no way to do this.
It took about one and a half hours, but it was still quite fast. The leather case cost 100 yuan, but the actual effect was far from 100 yuan. It felt comfortable and was no longer afraid of sweating from your hands and slipping the steering wheel. This was a safety issue. Finally, I would like to express my gratitude to the master again!
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
