Who is more worth buying coated glass or high-end glass film?
Vikixtp 
8 I don’t know when the front windshield was hit by a small stone, and I saw that many 5 Series car owners have experienced being hit by stones. In the past, my car had been driving 120,000 kilometers for seven years, and it had never been broken by a stone until it was sold. At most, it would only leave a mark. The glass of this car has been replaced once. It was replaced at a 4S shop. It was changed to Pilkington’s brand, but it was broken again this time. At first, I thought it wasn’t too big, so I went to the store to treat it with glass glue. After using it for a few months, it still cracked. It was about 30cm long. Later, I asked the owner of the glass shop. It is said that the black edge is the most fragile position of the windshield. If there is a hole in this position, it will easily crack. If you smash the glass to escape, you will also have to break it at the corners. It is difficult to make a hole in the middle. For safety reasons, it was decided to replace it. This time I decided to try it out with another brand and see if it would be better? Change to this Fuyao coated glass, wait for a while, and then share your feelings
Finally, there are comparison results from the ultraviolet tester test. As for which one to choose. Comrades can rush with confidence![]()
Finally, there are comparison results from the ultraviolet tester test. As for which one to choose. Comrades can rush with confidence
I don’t know when it happened
It was glued with glue. After using it for several months, the crack still became bigger. There was a crack about 30 cm long. I didn’t take a photo. Why do I feel that this glass glue is useless?
Looking at it a little distressed, the master said that in order to take pictures, the crack had to be widened.
start preparations
I put down all things first.
The master used thread to remove the glass glue.
After trying this coated glass to have a good thermal insulation effect, I decided to give it a try to avoid the trouble of pasting the film.
One of BMW’s original designated brands
The glass was taken off, and it felt like it was moving very fast.
The number of the coated glass can be scanned to identify and prevent counterfeiting.
Glass glue construction is very important.
The QR code of the glass model can also be recognized.
Information recognized after scanning the code.
After installation, it will be blue when photographed from the outside. There is a certain degree of privacy.
Do you know what the middle box does? Leave a message if you know.
The effect of seeing from the inside is okay with the clarity.
This plastic part seems to be a little aging
I first used an ultraviolet tester to measure the front glass film of Dragon Film at the price of 3000. The data before it was not blocked by the glass film was more than 2000, but after it was used, it was less than 200.
I measured it in my car, and the data on the coated glass was less than 200.
I also tested the film donated by the 4S shop on the side door. The data is more than 1700, which is basically useless.
This comparison makes the results very clear. As for how to choose, I think if you want to change the glass, comrades can rush it and directly choose the coated glass. If you don’t change the glass, you still need to put a better film on.
Hot Information
Tesla Autopilot and similar automated driving systems get ‘poor’ rating from prominent safety group
April 1, 2024 Localization of EV parts without production scalability may not help cut EV price, says President, Amara Raja
March 27, 2024 
JCTSL may turn bus stands into charging points for e-buses
March 27, 2024 You May Like
